Making rolling doors

I purchased the teak several month ago from an exotic wood place in MD. Today I spent time at a neighbor’s workshop cutting the would down to size. The rolling door will be 1/2in slats of would with two 1in center pieces with handles. The doors will open in the middle. I purchase some stainless handles for the 1in boards. It should look nice and match (with the exception of the hand carved handles) the rolling doors in the rest of the boat. I’ll post pictures when I’m done. Still have to round-over the edges and then glue the cloth on the back, varnish the mess, and install them.
The picture today is of the bow of my boat from the port side of the mast.